Lipo Sack for Safely Charging and Storing your lipos.
Please read before using
your new LipoSack
IMPORTANT USE AND SAFETY INSTRUCTIONS
Thank
you for purchasing a LipoSack. Please read these instructions before using your
new LipoSack. Adherence to these simple instructions will ensure many years of
use of this product.
The use of a LipoSack does not guarantee
total protection of surrounding surfaces. It is simply intended to mitigate the
effects of a battery failure during charging or after a crash.
Battery safety:
·
Lithium
Polymer batteries are volatile. Failure
to adhere to established charging guidelines may result in fire, personal injury
and damage to property if charged or used improperly.
·
The makers of LipoSack or its
distributors or retailers assume no liability for failures to comply with these
use and safety guidelines.
·
By purchasing this product, the
buyer assumes all risks associated with its intended use. If you cannot comply
with these guidelines please return this product unused to your retailer.
1)
Charge batteries in a safe area away from flammable materials and only on
a non-flammable surface in a vented area. Do not discharge
batteries below 3 volts/cell. Doing so may result in
cell damage and subsequent cell venting upon a subsequent charge.
2)
Do not recharge damaged batteries. Dispose of damaged batteries in the
proper manner.
3)
Some Lipo chargers on the market may have technical deficiencies that may
cause it to charge the battery incorrectly or at an improper rate. It is your
sole responsibility to assure that the charger you purchased works properly.
Always monitor the charging process to assure batteries are being charged
properly. Failure to do so may result in cell damage or fire.
4)
In the event of a crash, you must remove the battery from the model for
observation and place in a safe open area away from flammable materials.
LipoSack Use Instructions:
1)
Ensure that charger rate is properly set and polarity is correct.
2)
Attach charging leads to battery.
3)
Place battery in LipoSack towards the bottom.
4)
Place LipoSack on non-flammable surface.
5)
Route charge leads through vent at the top seam of the LipoSack.
6)
Close top flap of LipoSack and press hook and loop closure fully closed.
7)
Charge battery using proper charging practices.
FREE
REPLACEMENT GUARANTEE
Avoid damage
to the LipoSack. Replace if it becomes ripped, worn or is involved in a battery
failure.
If your
LipoSack is involved in a failure resulting in a venting of the battery and fire
return it to www.purehobby.com
with a statement of the circumstances and receive a replacement LipoSack
free of charge!